Article: Electric actuators.(QE PRODUCT SHOWCASE)

Article: CMM.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     332 words ...The shop-hardened Phoenix DCC CMM is for small and medium-sized parts. With a capacity of 12 by 12 by 10 inches, the machine has fully covered ways, bearing and scales for full-shop protection. Scales are metal on steel structures for uniform thermal response. Built-in mechanical accuracy is

Article: Registrar.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     323 words ...The company is a full-service registrar offering registration to all the ISO standards, including ISO 9001: 2000, ISO/TS 16949, AS9100 and ISO 14001. The company specializes in third-party assessments and public training for many industries, including aerospace, healthcare, education, metals and

Article: Videoscopes.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     346 words ...The 6 and 8 millimeter diameter series of videoscopes are available in three configurations: non-articulating, two-way articulating and four-way articulating. The videoscopes come in working lengths from 1.5 to 15 meters. The products have a high-resolution, 1/4-inch color CCD image sensor and

Article: Controller.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     334 words ...The TouchPanel controller for Instron 3300 Series electromechanical instruments can be used for tension and compression tests, and quality control screening of materials and components. Test data can be transferred to a memory stick or printed to a local device. The product has two testing modes:

Article: Climatic testing.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     350 words ...The 340-40 and 340-70 environmental chambers for climatic testing are suited for 3-D components and assemblies. A dehumidifier coil prevents condensation on test specimens and a psychrometric humidity measurement system maintains precise levels of heat and humidity while operating tests. Chambers

Article: Training videos.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     326 words ...From the creator of the "Auditing Nuts and Bolts" video, "The ISO/TS Auditors are Coming," has been updated for the automotive industry. This video training program includes ISO/TS requirements for the automotive industry, ISO/TS 16949 pre- and post-knowledge tests, and a summary of review notes.

Article: CMM software.(QE PRODUCT SHOWCASE)
Quality;  April 1, 2005 ;     347 words ...Calypso 4.0 is a CAD-based programming software for CMMs with the ability to self-center scan a spline and create a cylinder for use as a datum. Optimized clearance planes allow users to control the clearance planes relative to the base alignment, machine system or secondary alignments. Version 4.0