Article: Initial a necklace.

Article: Frame of reference: how to build frames and mount your favorite ...
Popular Mechanics;  September 1, 2003 ;     700+ words ... ... assembly while the glue sets. Then, spread glue on the back of the molding and clamp ... saw (Photo 2). Use a small brush to spread glue on the mitered ends and assemble the ... cutting the stock to rough length, spread glue on the back of the molding and use spring ...

Article: Clean Room.(detailed instructions on building a versatile storage ...
Popular Mechanics;  November 1, 1999 ;     700+ words ... ... screw the partitions to the top panel. Spread glue in the joining plate slots for the joints ... bottom, and fasten them with screws. Spread glue in the slots and on the plates for the ... into the short partitions (Photo 7). Spread glue in the slots and on the joining plates ...

Article: Garden retreat: a stunning focal point for the well-dressed ...
Popular Mechanics;  April 1, 2002 ;     700+ words ... ... all parts for one of the lattices and spread glue on the joints. Assemble the frame and ... to size and chamfer the top edges. Spread glue on the top end of each lattice and on ... pieces on the segment below. Then, spread glue on the mating surfaces, reposition ...

Article: Surround Sound.
Popular Mechanics;  November 1, 2000 ;     700+ words ... ... workbench, and cut the slots (Photo 1). Spread glue in the slots, along the edges of the ... assembly. To assemble a cabinet side, spread glue in the stile mortises and on the rail ... the two pieces (Photo 9). Next, spread glue in the slots, on the plates and on ...

Article: Table stakes: how to build the PM Poker table.(PM DIY HOME: HOME ...
Popular Mechanics;  February 1, 2008 ;     700+ words ... ... Then, flip the slats over and spread glue on the edges (3). Roll the ... because it has a longer open time. Spread glue on one side of the core (11 ... core on the backer veneer, then spread glue and add the top veneer. Cover ...

Article: Floor lamp: distinctive corbel support and a wide, stable base ...
Popular Mechanics;  November 1, 1997 ;     700+ words ... ... longer than the finished length. Spread glue on the mating surfaces of two of the ... half of the post to finished length. Spread glue on the mating faces of the post halves ... upside down in the bench vise, then spread glue and position the lower base panel over ...

Article: Stay Tuned.(children's desks)(Brief Article)
Popular Mechanics;  November 1, 1999 ;     700+ words ... ... to size, and cut the joining plate slots in its top edge. Spread glue in the slots and on the plates. Clamp it in place until the ... the workpiece to the bench. To assemble either grid, first spread glue on the joining plates and in the plate slots. Glue and clamp ...