Article: Turn-mill center provides overlapped twin turning--Clausing Industrial, Booth A-8454.(On Display At IMTS)

Article: Brass Mill Center in Waterbury searching for new ...
Waterbury Republican-American (Waterbury, CT);  February 25, 2005 ;     700+ words ... ... Silvestrini Feb. 25--Waterbury's Brass Mill Center and Commons is seeking the third general ... Malone will likely remain at the Brass Mill Center in at least a part-time capacity until ... influence the direction of the Brass Mill Center because the Waterbury complex is one ...

Article: Brass Mill Center mall expands hours.
Waterbury Republican-American (Waterbury, CT);  January 26, 2007 ;     656 words ... ... surveys and focus groups, the Brass Mill Center has permanently added three additional ... of the year, apply only to the Brass Mill Center, Pollack said. Each of the stores ... investment trust that owns the Brass Mill Center and Commons, is extending shopping ...

Article: State investigating Brass Mill Center over gift ...
Waterbury Republican-American (Waterbury, CT);  September 7, 2006 ;     700+ words ... ... investigating whether the owner of Brass Mill Center is illegally charging dormancy fees ... Pollack, marketing director of Brass Mill Center. "The plastic card expires and the ... otherwise restricted by law." The Brass Mill Center cards have been issued only since the ...

Article: Double-sided productivity: this shop gets the most out of its ...
Modern Machine Shop;  September 1, 2007 ;     700+ words ... ... multitasking machine such as the turn-mill center to bolster the production resources needed to meet its goals. The turn-mill center appealed to EWS because its modular construction ... As Mr. Weigele explains. "Our turn-mill center

Article: Turn-mill center for machining large parts--Mori ...
Modern Machine Shop;  August 1, 2008 ;     550 words ... ... accuracy and flexibility, the NT6600 DCG/4000CS turn-mill center features a large Y-axis travel, a fast Z-axis rapid traverse ... and enable high speed rotation. Additionally, the turn-mill center features DCG (Driven at the Center of Gravity) technology ...

Article: Turn-mill center with modular system.(Products)
Production Machining;  June 1, 2007 ;     407 words ...The Traub TNX65/42 turn-mill center is designed as a modular system equipped with two, three or ... much as 65 mm and a length of as much as 300 mm. The turn-mill center has identical main and counter spindles, and the tool mountings ...

Article: Turn-mill center for machining large parts--Mori ...
Production Machining;  August 1, 2008 ;     581 words ... ... accuracy and flexibility, the NT6600 DCG/4000CS turn-mill center features a large Y-axis travel, a fast Z-axis rapid traverse ... and enable high-speed rotation. Additionally, the turn-mill center features DCG (driven at the center of gravity) technology ...