|
|
Article: Address metrology challenges: a new probe enables measurement of 3-D form and surface finish in the same data set, providing accurate quality measurements of challenging microscale parts.(QUALITY INNOVATIONS)(InsituTec)
- Article from:
- Quality
- Article date:
- August 1, 2009
- Author:
CopyrightCOPYRIGHT 2009 BNP Media. This material is published under license from the publisher through the Gale Group, Farmington Hills, Michigan. All inquiries regarding rights should be directed to the Gale Group. (Hide copyright information)
|
[ILLUSTRATION OMITTED]
Small part measurements can lead to big problems if done incorrectly. With parts getting smaller and tolerances getting tighter, it is important to consider the measurement method and device carefully.
InsituTec's (Charlotte, NC) MicroTouch sensor is able to measure micro and nanoscale parts and features that currently cannot be measured using other technologies. The sensor is a dimensional measurement scanning probe based on the company's standing wave technology.
The MicroTouch fills a need in the marketplace, explains Bethany Woody, president and co-founder of InsituTec. The technology behind the MicroTouch was ...