Article: A fine gamma' + alpha cellular structure in Fe-37.3 Wt Pct Ni-3.6 Wt Pct Al-3.3 Wt Pct Ti-0.2 Wt Pct C and its influence on high-temperature tensile properties

Article: Discontinuous precipitation at [001] twist boundaries in Cu-0.75 ...
Metallurgical and Materials Transactions;  May 1, 2001 ;     700+ words ... ... boundaries in Cu0.75 wt pct Be alloy bicrystals ... Hornbogen has yielded grain-boundary diffusion data ... of a Cu-0.75 wt pct Be alloy. We have ... sub 0^, of grain-boundary diffusion against ... in Cu-0.75 wt pct Be alloy bicrystals ...

Article: The cellular interlamellar and growth-front interphase boundaries ...
Metallurgical and Materials Transactions;  August 1, 2002 ;     700+ words ... ... front interphase boundaries in Cu-3 wt pct Ti reveals an influence of crystallography ... electron microscopy (TEM) at the grain-boundary segments and the sharp faceting of ... complex defect networks. In Cu-3 wt pct Ti (all compositions are in weight ...

Article: Diffusion along grain and interphase boundaries in alpha Zr and ...
Metallurgical and Materials Transactions;  March 16, 2002 ;     700+ words ... ... interphase boundaries of a Zr-2.5 wt pct Nb alloy are presented. The conventional ... grain boundaries and Zr-2.5 wt pct Nb (interphase boundaries): Zr ... Zr-Nb). Data obtained from grain boundary diffusion (GBD) and interphase ...

Article: Microstructure and Yield Strength of UDIMET 720LI Alloyed with ...
Metallurgical and Materials Transactions;  November 1, 2005 ;     700+ words ... ... U720LI with a two-phase alloy Co-16.9 wt pct Ti in various contents. The microstructure ... alloys with the addition of Co-16.9 wt pct Ti, and its volume fraction increased ... increase in the addition of Co-16.9 wt pct Ti. The results of exposure at 750 C show ...

Article: Relationship between austenite dislocation density introduced ...
Metallurgical and Materials Transactions;  July 1, 2002 ;     700+ words ... ... M^subS^) temperature of an Fe-17 wt pct Mn alloy was quantitatively investigated ... that the austenite hardness of an Fe-25 wt pct Mn alloy, which was measured at 573 K ... cycles between 303 and 573 K in an Fe-17 wt pct Mn alloy. The objective of their study ...

Article: Effects of heat treatment and alloying elements on the ...
Metallurgical and Materials Transactions;  March 1, 2001 ;     700+ words ... ... microstructures and mechanical properties of 0.15 wt pct C transformation-induced plasticity ... mainly focused on cases of a 0.2 to 0.4 wt pct carbon content, because higher volume ... the carbon content is lowered to 0.15 wt pct in order to enhance the weldability and ...

Article: Electrolytic Deposition and Diffusion of Lithium onto Magnesium-9 ...
Metallurgical and Materials Transactions;  October 1, 2009 ;     700+ words ...The electrolytic deposition and diffusion of lithium onto bulk magnesium-9 wt pct yttrium alloy cathode in molten salt of 47 wt pct lithium chloride and 53 wt pct potassium chloride at 693 K were investigated. Results show that magnesium ...