Article: Microstructure and Yield Strength of UDIMET 720LI Alloyed with Co-16.9 Wt Pct Ti

Article: The cellular interlamellar and growth-front interphase boundaries ...
Metallurgical and Materials Transactions;  August 1, 2002 ;     700+ words ... ... front interphase boundaries in Cu-3 wt pct Ti reveals an influence of crystallography ... complex defect networks. In Cu-3 wt pct Ti (all compositions are in weight ... EXPERIMENTAL PROCEDURE The Cu-3 wt pct Ti alloy was cast from Cu shot (99 ...

Article: A fine gamma' + alpha cellular structure in Fe-37.3 Wt ...
Metallurgical and Materials Transactions;  June 1, 1999 ;     700+ words ... ... pct Ni-3.6 wt pct Al-3.3 wt pct Ti-0.2 wt pct C alloy, which reveals ... wt pct Ni3.6 wt pct Al-3.3 wt pct Ti-0.2 wt pct C on aging at 823 ... pct Ni-3.6 wt pct Al-3.3 wt pct ...

Article: Analysis of the Cu-3 Wt Pct Ti cellular ...
Metallurgical and Materials Transactions;  August 1, 2002 ;     700+ words ...The cellular-interlamellar interface in Cu-3 wt pct Ti is modeled employing three different theoretical approaches ... INTRODUCTION THE equilibrium precipitate phase in Cu-3 wt pct Ti has a Cu^sub 4^Ti composition and occurs in two morphologies ...

Article: Microstructure Characterization and Creep Deformation of an Al-10 ...
Metallurgical and Materials Transactions;  December 1, 2004 ;     700+ words ...The creep behavior of a cryomilled Al-10Ti-2Cu nanocomposite has been studied at temperatures of 533, 588, and 644 K at initial applied stresses ranging from 55 to 117 MPa. Although the strain rates fall within the 10^sup -10^ to 10^sup -9^ S^sup -1^ regime, we observe no evidence of threshold-type

Article: Relationship between austenite dislocation density introduced ...
Metallurgical and Materials Transactions;  July 1, 2002 ;     700+ words ... ... M^subS^) temperature of an Fe-17 wt pct Mn alloy was quantitatively investigated ... that the austenite hardness of an Fe-25 wt pct Mn alloy, which was measured at 573 K ... cycles between 303 and 573 K in an Fe-17 wt pct Mn alloy. The objective of their study ...

Article: Effects of heat treatment and alloying elements on the ...
Metallurgical and Materials Transactions;  March 1, 2001 ;     700+ words ... ... microstructures and mechanical properties of 0.15 wt pct C transformation-induced plasticity ... mainly focused on cases of a 0.2 to 0.4 wt pct carbon content, because higher volume ... the carbon content is lowered to 0.15 wt pct in order to enhance the weldability and ...

Article: Electrolytic Deposition and Diffusion of Lithium onto Magnesium-9 ...
Metallurgical and Materials Transactions;  October 1, 2009 ;     700+ words ...The electrolytic deposition and diffusion of lithium onto bulk magnesium-9 wt pct yttrium alloy cathode in molten salt of 47 wt pct lithium chloride and 53 wt pct potassium chloride at 693 K were investigated. Results show that magnesium ...